By Matt Hale, International Sales & Marketing Director, HRS Heat Exchangers

Since the first spiral heat exchanger was proposed back in the 19th century, they have become synonymous with the treatment of slurries and wastewater; materials which have a high fouling risk, are viscous, or which contain fibres and solid materials. However, in many situations the performance of a corrugated tube heat exchanger is equal to or better than that of a spiral design. Not only that, but corrugated tube designs provide a number of additional advantages in terms of day-to-day operation and maintenance.

Proponents of spiral heat exchangers (sometimes known as shell and coil heat exchangers) cite the following advantages as making them suitable for handling challenging fluids:

1. Good thermal performance, even where the temperature difference between the two materials is small;
2. The spiral design and use of a single channel is claimed to prevent fouling and be ‘self cleaning’
3. Compact design makes them suitable for installations where space and/or access is restricted;
4. The counter-current flow provides an effective way to recover waste heat.

Based on such claims, it would seem that spiral heat exchangers are the ideal option for high-fouling wastewater and sludge situations. However, given how frequently clients choose to replace their existing spiral heat exchangers (SHEs) with corrugated tube units, some of these claims need closer inspection.

Thermal performance

There is no doubt that in theory SHEs offer greater thermal efficiency than conventional smooth surface tubular designs due to their large surface area and true counter-current flow. However, this assumes that the barrier between the product and service fluids is kept clean and operates efficiently at all times. In practice, fouling frequently occurs, interfering with thermal transfer. Where the heat exchanger is used for sludge-to-sludge applications, this fouling layer can create a double barrier to efficient heat transfer.

While these comparisons hold true for smooth tube heat exchangers, they do not always apply to corrugate tube heat exchangers. For example, like SHEs, the tube-in-tube HRS DTI Series is a true counter-current heat exchanger with the product flowing through the inner tube, and the service fluid flowing through the surrounding shell. The use of HRS corrugation technology increases heat transfer and operational efficiency, while also minimising fouling.

Non-fouling and ‘self cleaning’ designs

The design of SHEs can create turbulent flow inside the exchanger. In turn this is claimed to reduce the likelihood of fouling, and that where blockages do start to occur, product flow speeds up; creating a ‘scrubbing’ effect that dislodges the blockage (so-called ‘self cleaning’). This is fine in theory, but in our experience is unlikely in many real world situations, particularly where SHEs are used with sludge. In fact, when you read further into manufacturers’ brochures, ‘self cleaning’ often becomes ‘virtually no fouling and clogging’ – two very different claims.

Newer designs do not have the same support framework to separate the coils as some older models, as such structures were ideal at picking up rags and fibres from the sludge, leading to further blockages and a consequent reduction in heat exchange efficiency. As a result, manufacturers of SHEs also claim that their units are easy to clean. However, it is not uncommon to have to remove 40-50 bolts just to open the unit. Once opened, the construction means that the service fluid channel contains a large number of brackets which not only give the heat exchanger its rigidity, but make cleaning difficult in sludge-to-sludge situations. There is also the issue of the expensive bespoke gaskets which are used to seal SHEs, and which need to be replaced each time the cover is refitted.

SOURCE TO COMPLETE ATICLE ABOUT HEAT EXCHANGER TECHNOLOGY OPTIONS

Media

Taxonomy

• Gravity-film Heat Exchanger