Wastewater process plant diagram
Published by hasan nikkhah in Academic
Here is my process for treating wastewater. any suggestion? it is an oily wastewater.
It is for my bachelor degree. so if there is any mistake sorry guys.
Tags
Category: Academic
- Industrial
- Water & Wastewater
- Waste Management
- wastewater
4 Comments
What's the COD and BOD load removal efficiency you are aiming at?
Published by Vitor Vieira, MSc.
How are you going to treat the COD and BOD load?
Published by Amir Bahadori
2 Comments
Let me to say you can be using modern technology in processing like MBR & MBBR ,SBR , RBC . this technology to remove and reduce the bod and cod approximate 95% and above
Published by ashraf shawqi, ZAMEL OPERATION & MANTANINCE
nice question. I'll upload it ASAP .just to let u know the influent COD is about 6000mg/L and The oil and grease content is 2700 mg/Lit. At first stages (2 API and DAF) my goal is to decrease Oli content As much as possible. The effluent is going to have the same character as it's going to use for agricultural use
Published by hasan nikkhah
same questions as Ken Ravon
Published by Jean-Lin Laurouaa
What are the wastewater characteristics? What are the discharge limits you are trying to meet?
Published by Ken Ravon, Solutions Recovery International - CEO
1 Comment
nice question. I'll upload it ASAP .just to let u know the influent COD is about 6000mg/L and The oil and grease content is 2700 mg/Lit. At first stages (2 API and DAF) my goal is to decrease Oli content As much as possible. The effluent is going to have the same character as it's going to use for agricultural use
Published by hasan nikkhah