Tube Settler Media Calculation

How can I calculate the quantity of tube settler media in the clarifier tank? 

Which factors contribute most to the calculation?

Taxonomy

• Flocculation
• Treatment Methods
• Coagulants
• Water Treatment & Control
• Waste Water Treatments
• Wastewater Treatment
• Water Treatment Solutions
• Total Dissolved Solids (TDS)

2 Answers

1. Tube settlers and parallel plates increase the settling capacity of circular clarifiers and/or rectangular sedimentation basins by reducing the vertical distance a floc particle must settle before agglomerating to form larger particles

   Tube settlers are based on different theory that states that settling is dependent on settling area rather than detention time. Keep the angle of inclination of Tubes between 45 degree and 60 degree. Since above 60 degree angle will cause them to be ineffective and below 45 degree angle will cause choking problems.
   The equations for settling is simply derived from time- distance-speed relationship, which further calculates the distance required to settle the particle with specific settling velocity.Solids loading are less (as in case of municipal wastewaters of industries with low sludge post treatments (less inert TSS in inlet and less yield). These have a hydraulic radius of 80 mm or even 60 mm for hexagonal chevron model which keeps the velocity of settling low through pipes and thus the Reynold's number.

   When we are to handle large quantity of sludges we work with lamella plates spaces about 100 mm apart (spacing can even be different based on requirements and quantity of sludges generated). 

   
   Since the water is supplied through small channels the fluid attains least turbulence and thus keeps the control over flow pattern.

   Advantages of Tube Settlers

   The advantages of tube settlers can be applied to new or existing clarifiers/basins of any size:

   1. Clarifiers/basins equipped with tube settlers can operate at 2 to 4 times the normal rate of clarifiers/basins without tube settlers.
   2. It is possible to cut coagulant dosage by up to half while maintaining a lower influent turbidity to the treatment plant filters.
   3. Less filter backwashing equates to significant operating cost savings for both water and electricity.
   4. New installations using tube settlers can be designed smaller because of increased flow capability.
   5. Flow of existing water treatment plants can be increased through the addition of tube settlers.
   6. Tube settlers increase allowable flow capacity by expanding settling capacity and increasing the solids removal rate in settling tanks.

   Tube settlers increase the settling capacity of circular clarifiers and/or rectangular sedimentation basins by reducing the vertical distance a flock particle has to travel downwards for settling or to agglomerate to form larger particles.

    

   http://www.tubesettlers.com/tubesettlers/frameCalculate.php

    

2. The tank size matters. 

   We can supply tube settler with PP material, customized size and thickness.

   If you have any requirements, pls contact me freely.

   Email: rita@sintafrp.cn

   1 Comment

   1. Simplest thing is please refer to standard Surface loading Rates given in various references. For Raw water they vary from 4 -6 cum/sqm/hr (on plan area) for tube size of 50mm x 50mm with slant length of 600mm with inclination of 60 degree.

      If you want to go by first principle then there are formulae available linking Settling velocity of solids to Surface loading rates in renowned  reference books.