what percentage of tds level in water is good?
Published on by ahmed janahi in Technology
what percentage of tds level in water is good?
3 Answers
-
TDS is Total Dissolved Solids. Water dissolves the minerals present in the strata of soil it filers through in the case of ground water and, in the case of surface water, the minerals present in the soil over which it flows (rivers/streams) or over which it stands (lakes, ponds, reservoirs).The dissolved minerals in water are commonly referred to as Total Dissolved Solids (TDS). The TDS content of any water is expressed in milligrams /litre (mg/l) or in parts per million (ppm). These units are equivalent.
As per WHO standard as the basis and has been amended subsequently to take into account the fact that over exploitation of ground water which has the largest share of water supplied for human use has deteriorated to such an extent that the crucial parameters such as TDS, hardness, Chlorides, etc usually exceed the desirable levels substantially. Consequently, a higher permissible limit has been specified. Water used for drinking becomes unpalatable when the TDS level is above 500 mg/l, but lack of any better source enables people consuming such water to get used to its taste.
Water containing TDS concentrations below 1000 mg/litre is usually acceptable to consumers, although acceptability may vary according to circumstances. However, the presence of high levels of TDS in water may be objectionable to consumers owing to the resulting taste and to excessive scaling in water pipes, heaters, boilers, and household appliances (see also the section on Hardness).
Water with extremely low concentrations of TDS may also be unacceptable to consumers because of its flat, insipid taste; it is also often corrosive to water-supply systems "
-
As per BIS standards ,,,
-
Dear Ahmed, you can read a previous thread on this topic (Permissible range of TDS in drinking water) in Question and Answer section here http://bit.ly/1ot7F8O